Schedule a FREE home water test with a Culligan Water expert today!

Are There Disinfection Byproducts In Your Water?

Disinfection byproducts can enter your water supply in several different ways. In fact, there could even be disinfection byproducts in your cup of tea. According to a study conducted by the American Chemical Society, and distributed by Science Daily, “when boiled water is used to brew tea, residual chlorine in the water can react with tea compounds to form disinfection byproducts.” It is a problem that communities across the country face, but what are disinfection byproducts, and should you be concerned?

What Are Disinfection Byproducts?


According to Lenntech, disinfection byproducts are formed when a disinfectant reacts with an organic matter present in water. Typically, these organic substances have been seen to be humic acid or fulvic acid, but other organic matter can be involved, and they often enter the water through the decomposition of plants. The reaction creates either chemical, organic, or inorganic substances.

The most common disinfectant that is used is chlorine. Which disinfectant is used and the amount of it added to water affects what byproduct is formed and in some cases, if one is even formed to begin with. If there is a very minimal amount of disinfectant added to the water, the risk for byproduct is significantly reduced.

Disinfection byproducts are broken down into two categories: Total Trihalomethanes (TTHM) and Haloacetic Acids (HAA5). For TTHMs, the maximum contaminant level is 0.080 mg/L while HAA5s have a maximum contaminant level of 0.060 mg/L under federal EPA rules.

How Are Disinfection Byproducts Regulated?


Disinfection byproducts are regulated, and public water systems are required to monitor for them. According to the Minnesota Department of Health, “All public water systems that disinfect must regularly test their treated water to determine if regulated DBPs are present and at what levels.” Your utility reports TTHM and HAA5 levels in its annual Consumer Confidence Report, and a test of your own tap is how you find out what is reaching your fixtures. If you have health questions, talk to your doctor or your county health department.

Disinfection byproducts are a side effect of disinfection, which public water systems rely on to control microorganisms as water travels through pipes and storage tanks. 

What Can You Do At Home?


While your local water authority will typically take care of the disinfection byproducts in your water, there are steps you can take at home. Activated carbon filtration and reverse osmosis systems can reduce certain disinfection byproducts at the tap; check a system’s performance data sheet for what it is certified to reduce. Take a look at rental and purchasing options today by clicking here.

Your utility’s annual water quality report is the best place to see how disinfection byproduct levels compare with the limits.

Works Cited:

Comments